Arctic Cat 2012 DVX 90 Service Manual page 30

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
3. Remove the V-belt; then remove the movable drive
face (A). Account for a bushing (B) and speed lim-
iter spacer (C).
4. Remove the centrifugal clutch housing; then remove
the centrifugal clutch shoe/driven pulley assembly.
5. Remove the starter reduction gear shield; then
remove the starter countershaft housing. Account for
a thrust washer (A) and countershaft (B).
 NOTE: The thrust washer and countershaft may
come out with the countershaft housing.
6. Remove the starter one-way nut using Starter One-
Way Clutch Nut Wrench (p/n 0444-191); then install
Starter One-Way Clutch Puller (p/n 0444-188) to the
one-way housing.
www.mymowerparts.com
7. Install the push-bolt into the puller; then using two
wrenches as illustrated, tighten the push-bolt until
the one-way clutch is free of the crankshaft.
YT021A
 NOTE: It may be necessary to strike the head of the
bolt sharply with a hammer after tightening to free the
YT022
one-way housing from the crankshaft.
8. Make sure the transmission is in neutral; then
remove the gear position switch noting the orienta-
tion of the drive pin. Account for an O-ring.
YT024A
Manual
Table of Contents
YT104
YT104
YT028
29