Bin Mailbox Sensor (Pass Through) Removal - Lexmark T650 Service Manual

4062-XXX

5-bin mailbox sensor (pass through) removal

1. Remove the 5-bin mailbox left outer cover. Go to
2. If the lower pass through sensor needs to be removed, first remove the 5-bin mailbox rear door assembly.
Go to "5-bin mailbox rear door assembly removal" on page
3. Lift up the deflector gate above the sensor (pass through) and using a flat-blade screwdriver, release the
tabs securing the sensor.
4. Disconnect the appropriate harness from the controller card (J11) for the upper sensor (pass through) and
(J5) for the lower sensor (pass through).
Note: The use of a spring hook facilitates the unrouting of the cables. Remove the two screws (A) and lift the
left frame assembly to ease removal of the lower sensor (pass through) harness.
4-90
Service Manual
"5-bin mailbox left outer cover removal" on page
4-84.
A
Previous
4-85.
Next
Go Back