Lexmark T650 Service Manual page 104

4062
Error
code or
message
27x.15 Sensor (output pass
through) static jam
x = bin
number Applies to:
High capacity stacker
Mailbox
Offset stacker
Output expander
Sensor (mailbox
empty) static jam
Applies to:
Mailbox
27x.29 Sensor (output pass
through) lingering jam
x = bin
number Applies to:
Offset stacker
Mailbox
Output expander
High capacity stacker
27x.50 Sensor (output pass
through) lingering jam
x = bin
number Applies to:
Mailbox
27x.50 Left tamper does not
leave home position
x = bin
failure
number
Applies to:
Offset stacker
27x.51 Sensor (output pass
through) late jam
x = bin
number Applies to:
Mailbox
2-68
Service Manual
Error contents
Media remains on the sensor
(output pass through) during
the warm up sequence.
Media remains on the sensor
(mailbox empty) during the
warm up sequence.
The media reached the sensor
(output pass through) but did
not clear it in the specified time.
The media reached the sensor
(output pass through) but did
not clear it in the specified time.
The sensor (left tamper HP)
does not detect that the tamper
has moved from home position.
The media is late reaching the
sensor (output pass through)
within the specified time.
Description/Action Possible repair actions
See "Sensor (output pass
through) static jam service
check" on page 2-144.
See "Sensor (mailbox empty)
static jam service check" on
page 2-146.
See "Sensor (output pass
through) lingering jam
service check" on
page 2-143.
See "Sensor (output pass
through) lingering jam
service check" on
page 2-143.
1. Check all the connections on
the output option controller
card.
2. Check the tamper drive belt
for damage and replace if
needed.
3. Replace the left tamper
motor assembly.
Go to "SFP stapler assembly
tamper drive motor
assembly removal" on
page 4-181.
4. Replace the sensor (tamper
HP).
Go to "SFP stapler assembly
sensor (tamper HP left and
right) removal" on
page 4-188.
4. Replace the output option if
problem remains.
See "Sensor (output pass
through) late jam service
check" on page 2-142
Previous
Next
Go Back