Exiting Diagnostics Mode (Models T650, T652, And T654) - Lexmark T650 Service Manual

EP SETUP
EP Defaults
Fuser Temp
Fuser Page Count
Warm Up Time
Transfer
Print Contrast
Charge Roll
Gap Adjust
EVENT LOG
Display Log
Print Log
Clear Log
EXIT DIAGNOSTICS

Exiting Diagnostics mode (models T650, T652, and T654)

Select Exit Diagnostics to exit the Diagnostics menu. Resetting the Printer displays, the printer
performs a POR, and returns to Ready mode.
REGISTRATION
Print registration makes sure the printing is printed properly aligned on the page.
The settings available are:
Top Margin
Bottom Margin
Left Margin
Right Margin
Quick Test
To set print registration:
1. Select REGISTRATION from the DIAGNOSTICS menu.
2. Select Quick Test, and press
To print the Quick Test page:
a.
Press
b. Press
The message Quick Test Printing... appears on the display.
Retain this page to determine the changes you need to make to the margins settings.
3. Use or
4. Use to decrease or
The message Submitting selection displays, and the original REGISTRATION screen appears with
the beside the previously selected margin setting.
See "EP Defaults" on page 3-21
See "Fuser Temperature (Fuser Temp)" on page 3-21
See "Fuser Page Count" on page 3-21
See "Warm Up Time" on page 3-21
See "Transfer" on page 3-21
See "Print Contrast" on page 3-22
See "Charge Roll" on page 3-22
See "Gap Adjust" on page 3-22
See "Display Log" on page 3-23
See "Print Log" on page 3-23
See "Clear Log" on page 3-24
.
until the appears next to Quick Test.
.
to select the margin setting you need to change, and press
to increase the values, and press
.
to reset the value.
Diagnostic aids
4062-XXX
Previous
Next
Go Back
3-5