Danfoss ECL Comfort 210 Installation Manual page 58

Installation Guide
MENU > Settings > Flow meter
MENU > Settings > Flow / power limit
Input type
Circuit
All
Choice of input type from flow / heat meter
* See Appendix "Parameter ID overview"
No input
OFF:
IM1 -
Flow / heat meter signal based on pulses.
IM5:
EM1 -
Flow / heat meter signal from M-bus.
EM5:
MENU > Settings > Flow / power limit
Actual (actual flow or power)
Circuit
All
The value is the actual flow or power based on the signal from flow / energy
meter.
MENU > Settings > Control par., fan
MENU > Settings > Flow / power limit
Limit (limitation value)
Circuit
All
This value is in some applications a calculated limitation value, based on the
actual outdoor temperature.
In other applications the value is a selectable limitation value.
* See Appendix "Parameter ID overview"
MENU > Settings > Flow / power limit
Adapt. time (adaptation time)
Circuit
All
Controls how fast the flow / power limitation adapts to the desired
limitation.
* See Appendix "Parameter ID overview"
OFF: The control function is not influenced by the 'Adapt.
time' .
1:
The desired temperature is adapted quickly.
50:
The desired temperature is adapted slowly.
58 DEN-SMT/DK
ECL Comfort 210 / 310, application A260
1x109
Setting range Factory setting
*
Setting range Factory setting
1x111
Factory setting
Setting range
*
1x112
Setting range Factory setting
*
The setting range for IM and EM depends on chosen subtype.
*
*
If the 'Adapt. time' is too low, there is a risk of unstable control.
*
VI.LG.F2.02
Danfoss District Energy