Danfoss ECL Comfort 210 Installation Manual page 4

Installation Guide
4 DEN-SMT/DK
ECL Comfort 210 / 310, application A260
Automatic update of controller software:
The software of the controller is updated automatically when the key
is inserted (as of controller version 1.11). The following animation will
be shown when the software is being updated:
Progress bar
During update:
• Do not remove the KEY
If the key is removed before the hour-glass is shown, you have
to start afresh.
• Do not disconnect the power
If the power is interrupted when the hour-glass is shown, the
controller will not work.
As this Installation Guide covers several system types, special system
settings will be marked with a system type. All system types are shown
in the chapter: 'Identifying your system type'.
°C (degrees Celsius) is a measured temperature value whereas K
(Kelvin) often is used for temperature differences.
The ID no. is unique for the selected parameter.
Example First digit
11174 1
-
12174 1
-
If an ID description is mentioned more than once, it means that there
are special settings for one or more system types. It will be marked
with the system type in question (e.g. 12174 - A266.9).
Parameters indicated with an ID no. like "1x607" mean a universal
parameter.
x stands for circuit / parameter group.
VI.LG.F2.02
Second digit Last three digits
1 174
Circuit 1 Parameter no.
2 174
Parameter no.
Circuit 2
Danfoss District Energy