Danfoss ECL Comfort 210 Installation Manual page 106

Installation Guide
ECA MENU > ECA system > ECA display
Contrast (display contrast)
Setting range
Adjust the contrast of the display.
0: Low contrast.
10:
High contrast.
ECA MENU > ECA system > ECA display
Use as remote
Setting range
OFF / ON
ECA 30 / 31 can act as a simple or normal remote control
for the ECL controller.
OFF:
Simple remote control, no room temperature signal.
ON: Remote control, room temperature signal is available.
*): Differently, depending on chosen application.
ECA MENU > ECA system > ECA communication
Slave addr. (Slave address)
Setting range
The setting of 'Slave addr. ' is related to the setting 'ECA
address' in the ECL controller.
In the ECL controller it is selected from which ECA 30 / 31
unit the room temperature signal is received.
A: The ECA 30 / 31 has the address A.
B: The ECA 30 / 31 has the address B.
106 DEN-SMT/DK
ECL Comfort 210 / 310, application A260
Factory setting
0 ... 10 3
Factory setting
*)
Factory setting
A / B A
When set to OFF: The ECA menu shows date and time.
When set to ON: The ECA menu shows date and room temperature
(and for ECA 31 relative humidity).
For installation of an application in an ECL Comfort 210 / 310 controller
the 'Slave addr.' must be A.
If two ECA 30 / 31 are connected in the same ECL 485 bus system, the
'Slave addr.' must be "A" in the one ECA 30 / 31 unit and "B" in the other.
VI.LG.F2.02
Danfoss District Energy