Verification Or Replenishing Of Oil Level In Gear - Rotax 125 MAX Installation Instructions And Operators Manual

3) Verification or replenishing of oil level in gear compartment
General
Oil specification
Procedures
Graphic
Effectivity: 125 MAX/Junior MAX/Mini MAX/Micro MAX
Edition 1/Rev. 0
The gear compartment has already been filled with the appropri-
ate amount of oil by the engine manufacturer. However, before
engine installation into the frame (chassis), the oil level must be
verified and replenished if necessary.
NOTE: The filling capacity is 6.10 cu in. (0.0265 US
gal).
Part no.
n.a.
See Fig. 1.
NOTE: By removing the Allen screw (2) the oil can be
drained from the gear compartment.
Step
1 Remove venting screw (1).
2 Remove drain plug (2).
3 Drain gear oil completely.
4 Install drain plug (2) with new sealing.
5 Fill in gear oil as specifed (6.10 cu in. (0.0265 US gal)).
6 Tighten venting screw (1) by hand.
Oil level check
1. Venting screw
Fig. 1
BRP-Powertrain
Description
Gear oil specification
SAE30
Procedure
2. Drain plug
Application
gearbox
K00233_b
page 1-6
February 01/2014