Rotax 125 MAX Installation Instructions And Operators Manual page 19

Start button and
ON/OFF switch
Procedures
Ignition coil
Procedures
Effectivity: 125 MAX/Junior MAX/Mini MAX/Micro MAX
Edition 1/Rev. 0
NOTE: Polarity of the cable for start button and ON/
OFF switch is optional.
See Fig. 3.
Step
1 Connect the two 6 mm
ton (1).
2 Connect the two 2 mm
switch (2).
NOTE: Attach the wiring harness with the supplied ca-
ble ties to top side of chassis tubes and in the
area of the ignition coil support. Make sure that
plug connectors on the ignition pick-up and igni-
tion coil are free of stress.
NOTICE
WARNUNG
NOTE: The location of the ignition coil is adjustable
within the ablong holes in gear cover and igni-
tion coil yoke. Position ignition coil as far as
possible from the exhaust.
See Fig. 3.
Step
1 Attach ignition coil on the reduction cover, utilizing the sup-
plied attachment elements 2 pcs. rubber mount (6), 4 pcs.
Washer 6,4 (7) and 4 pcs. lock nut M6 (8).
2 On the top of the attachment screw of ignition coil connect
also the grounding cable (9).
NOTICE
WARNUNG
Step
3 Connect the wiring harness to the ignition coil (5).
4 Connect the wiring harness to the trigger coil (10).
5 Connect the wiring harness to the electric starter (11).
BRP-Powertrain
Procedure
2
/ S.W.G. 11 cables (3) with start but-
2
/ S.W.G. 16 cables (4) with ON/OFF
The ignition coil must be attached flexibly on
the gear cover, exclusively via the two rubber
mounts. Under any circumstances the igni-
tion coil may not touch any rigid parts of the
frame (e.g. seat strut).
Procedure
Pay special attention to proper ground
connection on gear compartment cover. An
interrupted grounding can ruin the ignition
coil.
Procedure
page 1-11
February 01/2014