5) Electrical components
5.1) Installation of the start button and ON/OFF switch
General
Procedures
Graphic
Effectivity: 125 MAX/Junior MAX/Mini MAX/Micro MAX
Edition 1/Rev. 0
Both items have to be fitted into top section (left or right) of the
front shield.
NOTE:
Hand-tighten the attachment nut of starter but-
ton and ON/OFF switch.
See
Fig.
2.
Step
1
Drill a ø22 mm (1/8") bore for the starter button (2) into either
left or right side of the front shield.
2
Approx. 40 mm (1.5") below drill a ø12 mm (0.5") bore for
the ON/OFF switch (1).
3
Attach start button furnished with rubber cap by hex. nut on
front shield.
4
Attach ON/OFF switch on the front shield with the 2 nuts
supplied.
Start button and ON/OFF switch
2
1. Start button
Fig. 2
BRP-Powertrain
Procedure
1
2. ON/OFF switch
February 01/2014
K00252
page 1-9