Replacing The Drive Belt - Toro ProCore 864 Operator's Manual

Figure 35
1. Spring retainer
D. Adjust the spring retainer to attain required
compressed spring length
E. Tighten the locknut against the spring
retainer to lock the adjustment.
F. Install the pulley shield and the coring head
cover.

Replacing the Drive Belt

Note:
You do not need to remove the outside
stomper arm to replace the drive belt.
Removing the Belt
1. Remove the rear coring head cover
Figure 36
1. Rear coring head cover
2. Remove the pulley shield mounting bolts and
remove the shield
3. Remove the fasteners securing the dirt shield
and the lower belt shield
the dirt shield and the lower belt shield.
2. 146 mm (5-3/4 inches)
(Figure 35).
(Figure
2. Pulley shield
(Figure 36).
(Figure 37). Remove
g007315
1. Lower belt shield
4. To release the idler spring tension, loosen the
locknut securing the spring retainer
and rotate the spring retainer.
36).
1. Spring retainer locknut
CAUTION
Springs are under tension, use caution
when adjusting or removing.
5. Loosen and remove the 2 locknuts and washers
g007316
securing the rotalink damper for the #1 stomper
arm (Figure
30
Figure 37
2. Dirt shield
Figure 38
39).
g007317
(Figure 38)
g007319