Pc-To-Printer Test Call Using Manual Dialing - Toshiba Strata DK24 Installation And Maintenance Manual

INSTALLATION-PERIPHERALS
SECTION 400-096-208
SEPTEMBER 1992
set the plugs to the "A-B" position.
•
If the PDIU-DS is connected to a DCE
device, set the plugs to the "B-C" position.
NOTE:
Do not cut the PERCEPTION jumper wire for
STRATA DK installations. The jumper wire is
cut for PERCEPTION applications only.
12.73 Assembling the PDIU-DS
1) Position the back panel to the PCB (see Fig-
ure 8-37).
2) Slide the back panel down into its side grooves.
3) Attach the bottom panel, and secure with the
four non-captive screws.
12.80 PDIU-DI/PDIU-DS Installation Tests
12.81 Paragraphs 12.82 ~ 12.86 provide tests for
five DIU call applications. The telephone and port
numbers used in these figures are provided for
explanation purposes only; when actually testing,
use port and telephone numbers appropriate for
RS-232
RS-232
FGURE 8-39

PC-TO-PRINTER TEST CALL USING MANUAL DIALING

LAPTOP PC
DKT/PDIU-DI
(201 )
SERIAL
PRINTER
PDIU-DS
DIU
TOSHIBA
POWER READY CONNECT
(203)
8-60
the system. Each of these tests can be conducted
with manual dialing from a digital telephone's dial-
pad or AT dialing from a personal computer's
keyboard; however, only the preferred method of
dialing for each application is presented. The Data
Interface User Guide in the Operating Procedures
section of this manual has additional information
useful for the tests.
12.82 PC-to-PC Test Call Using AT Commands
(see Figure 8-38)
1) DIU Programming:
•
Program 20: Ports 00 and 01. LEDs 01,
02, and 17 ON; all other LEDs OFF.
•
Program 39: Ports 00 and 01. DataÍCall
(DATA) (Code 56) and DataÍRelease
(DRLS) (Code 54) buttons should be
provided.
•
Default settings for PDIU-DI S-Regis-
ters.
2) Make sure PC 1 and PC 2 are on-line with a
communications software package and that
the communication parameters of each PC
and communication software package are set
STRATA DK
(Release 3 or higher)
MDF
PDKU
(PORT 01)
MDF
PDKU
(PORT 03)