Toshiba Strata DK24 Installation And Maintenance Manual page 344

REMOTE ADMINISTRATION & MAINTENANCE PROCEDURES
SECTION 400-096-600
SEPTEMBER 1992
STEP
1 Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 45
Press CR.
3 Enter the number 1.
The system will display the present dial plan code number (1 ~ 5).
Refer to the record sheet and enter the required code number.
4
Example: Code 2, enter 2.
5
To Exit Program/Store Data
A) To store data, press CR.
B) To exit this program, press # # CR.
STEP
1 Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 45
Press CR.
3 Enter the number 2.
4 Refer to the record sheet and enter the required CO line number.
Example: CO line 01, enter 0 1. The system will display
N or Y to define if the LED is on or off.
5 Refer to the System Record Sheet and change the CO line
status as required (Y or N).
Press SPACE to step to next CO line number.
6 To Exit Program/Store Data
A) To store data, press CR.
B) To exit this program, press # # CR.
TABLE RM-AL
PROGRAM 45-1
TOLL RESTRICTION DIAL PLAN
ACTION
TABLE RM-AM
PROGRAM 45-2
TOLL RESTRICTION DISABLE
ACTION
-40-
DISPLAY/PRINTOUT
>MODE PROG
P
P 45
P45
P45 1 1
P45 1 1 2
P45 1 1 2
P45 # #
P
DISPLAY/PRINTOUT
>MODE PROG
P
P 45
P45
P45 2
P45 2 01 N
P45 2 01 N Y
02 N
P45 2 01 N Y
02 N
P45 ##
P