Toshiba Strata DK24 Installation And Maintenance Manual page 345

EQUAL ACCESS, SPECIAL COMMON CARRIER NUMBERS & AUTHORIZATION CODE DIGIT LENGTH
STEP
1 Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 45
Press CR.
3 Refer to the record sheet and enter the item number (3 ~ 6).
Example: Item 3, enter 3. The system will display
the present equal access number or EA1 Code.
4 Refer to the System Record Sheet and enter the required number.
Example: 12345, enter 1 2 3 4 5 CR.
5 Enter code number 4. The system will display present authorization
code digit length. Refer to the System Record Sheet and enter
the required authorization code number digit length.
Example: 12, enter: 1 2 CR.
6 To exit this program, press # # CR.
NOTE:
Items 5 and 6 are entered the same way as 3 and 4, respectively.
STEP
1 Enter the Program Mode
At the >MODE prompt, enter
2 Enter the Program Number 45
Press CR .
3 Refer to the System Record Sheet and enter
desired code number. The system will display the present
override code number.
4 Refer to the record sheet and enter a new number if required.
Example: 1234. Enter:
5 To Exit Program/Store Data
A) To store data, press
B) To exit this program, press
REMOTE ADMINISTRATION & MAINTENANCE PROCEDURES
TABLE RM-AN
PROGRAM 45-3 ~ 6
ACTION
TABLE RM-AP
PROGRAM 45-8 ~ 9
TOLL RESTRICTION OVERRIDE CODE
ACTION
PROGCR .
8 or
1234 .
CR .
.
##CR
-41-
DISPLAY/PRINTOUT
>MODE PROG
P
P 45
P45
P45 3 NNNNN
P45 3 NNNNN 12345
P45
P45 4 00 12
P45
P45 ##
P
>MODE PROG
P
P 45
P45
9 for the
P45 8 NNNN
P45 8 NNNN 1234
P45 8 NNNN 1234
P45 ##
P
SECTION 400-096-600
SEPTEMBER 1992
DISPLAY/PRINTOUT