Toshiba Strata DK24 Installation And Maintenance Manual page 332

REMOTE ADMINISTRATION & MAINTENANCE PROCEDURES
SECTION 400-096-600
SEPTEMBER 1992
STEP
1
Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter the Program Number 32
Press CR.
3 Refer to the record sheet and enter the required port number.
Example: Port 01, enter 0 1.
4 Enter #. The present status for this port will be displayed.
5
Refer to the record sheet and enter the required
ringing code. Example: Code 0, enter 0.
6 Refer to the record sheet and enter the required
automatic off-hook code. Example: Code 11, enter 1 1.
7 To Exit Program/Store Data
A) To store data, press CR.
B) Continue returning to Step 3 until all Program 32 data
is entered.
C) To exit this program, press # # CR.
STEP
1 Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 33
Press CR.
3 Refer to the record sheet and enter the required
port number.
Example: Port 03, enter 0 3.
4 Enter #. The present data will be displayed.
5 Refer to the record sheet and enter the port number
that will be the hunt point.
Example: Port 00, enter 0 0.
6 To Exit Program/Store Data
A) To store data, press CR.
B) Continue returning to Step 3 until all Program 33
data is entered.
C) To exit this program, press # # CR.
TABLE RM-W
PROGRAM 32
AUTOMATIC PREFERENCE
ACTION
TABLE RM-X
PROGRAM 33
STATION HUNTING
ACTION
-28-
DISPLAY/PRINTOUT
>MODE PROG
P
P 32
P32
P32 01
P32 01# 100
P32 01 # 100 0
P32 01# 100 011
P32 01# 100 011
P32 ##
P
DISPLAY/PRINTOUT
>MODE PROG
P
P 33
P33
P33 03
P33 03# NN
P33 03# NN 00
P33 03# NN 00
P33 ##
P