Additional Guidelines - REMEHA Quinta Pro Installation, User And Service Manual

Fig.15 Different pressure areas
L
=
123157 - v.07 - 10082015
A 100/100 mm flue gas adapter (accessory) must be fitted for this connec­
tion.
Combustion air supply and flue gas discharge are possible in different
pressure areas and semi-CLV systems, with the exception of the coastal
area. The maximum permitted height difference between the combustion
air supply and the flue gas outlet is 36 m.
+
Tab.15 Maximum chimney length (L) in the various pressure zones
Quinta Pro
30
45
AD-0000030-01
65
90
115
Tab.16 Pipe reduction for each element used (parallel)
Diameter
60 mm
70 mm
80 mm
90 mm
100 mm
110 mm
130 mm
Tab.17 Pipe reduction for each element used (concentric)
Diameter
60–100 mm
80–125 mm
100–150 mm

6.5.5 Additional guidelines

For installing the flue gas outlet and air supply materials, refer to the in­
structions of the manufacturer of the relevant material. If the flue gas
outlet and air supply materials are not installed in accordance with the
instructions (e.g. not leakproof, not properly bracketed), this can result in
dangerous situations and/or physical injury. After installation, check at
least all flue gas outlet and air supply parts for tightness.
Direct connection of the flue gas outlet to structural ducts is not permit­
ted because of condensation.
Always clean shafts thoroughly when using lining pipes and/or an air
supply connection.
It must be possible to inspect the lining duct.
Connection in different pressure areas (C53, C83)
Flue gas outlet connection
Air supply connection
80 mm
20 m
20 m
-
-
-
Reduction table
45° bend
0.9 m
1.1 m
1.2 m
1.3 m
1.4 m
1.5 m
1.6 m
45° bend
1 m
1 m
1 m
Diameter
90 mm 100 mm 110 mm
36 m 36 m 36 m
36 m 36 m 36 m
2 m 8 m 34 m
- 4 m 32 m
- - 24 m
Pipe reduction
90° bend
3.1 m
3.5 m
4.0 m
4.5 m
4.9 m
5.4 m
6.2 m
Pipe reduction
90° bend
2 m
2 m
2 m
6 Installation
130 mm
36 m
36 m
36 m
36 m
36 m
27