Changing The Parameters; Changing The User-Level Parameters - REMEHA Quinta Pro Installation, User And Service Manual

9 Settings
Parame­ Description
ter
Minimum fan speed (offset)
Start speed
Tab.31 Adjustment for flue gas overpressure cascade
Parame­ Description
ter
Minimum fan speed (CH + DHW)
Minimum fan speed (offset)
Start speed
(1) Use the parameter setting for the gas type if the boiler has been adjusted for G31 (propane).
9.2

Changing the parameters

Fig.43 Changing the user parameters
1x
2x
AD-0000075-01
50
The boiler's control unit is set for the most common central heating sys­
tems. These settings will ensure that virtually every central heating system
operates effectively. The user or the installer can optimise the parameters
as required.
For operation in open-vented systems, several parameter settings must be
adjusted. Set the various parameters according to the values given in the
table below.
Caution
Modification of the factory settings may impair boiler operation.

9.2.1 Changing the user-level parameters

The parameters at user level (see parameter table) can be changed by the
user as required.
1. Press the two keys at the same time and then the
symbol flashes in the menu bar.
2. Select the user menu using the
: appears with flashing
3. Press the key again.
The set value °C (for example) appears and flashes.
4. Change the value by pressing the
use the key to change the value to
5. Confirm the value with the
: appears with flashing
6. Press the key twice to leave this menu and return to the opera­
tion display.
Note
The other parameters at user level are changed in the same way
as . After step 2, use the
ter.
30 45 65
50 50 0
30 30 25
30 45 65
18 18 18
0 0 0
25 25 25
key.
.
or keys. In this example,
°C.
key.
.
key to go to the required parame­
123157 - v.07 - 10082015
90 115
0 0
25 35
90 115
19 19
(1)
0 0
25 25
key until the