Table of Contents
Advertisement
Installation Instructions - Flush Installation
STEP 11 INSTALL OVERLAY PANELS
Install door panels:
• Open door to 90°. Remove the 6 Phillips head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, then lift off
the trim. Retain the screws.
• Slide the overlay panel into the door trim.
• Custom handles must be used with flush inset. Make
sure handles are attached before installing panels.
Dispenser Models Only:
• The dispenser controls protrude beyond the face
of the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the assembled freezer panel into the bottom
channel and slide into the hinge side trim.
• Reinstall the top trim piece with the screws.
• There are two sets of holes in the door trim. Replace
door trim by installing all of the screws in the two sets of
screw holes.
• Follow the same procedures to install the opposite panel.
• Discard the visor handle.
37
Advertisement
Table of Contents
