Table of Contents
Advertisement
Installation Instructions - Standard Installation
STEP 12 CONNECT WATER SUPPLY
(continued)
GE SmartConnect
Refrigerator Tubing Kits are available
™
in the following lengths:
2' (.6 m)
WX08X10002
8' (2.4 m) WX08X10006
15' (4.6 m) WX08X1 0015
25' (7.6 m) WX08X10025
• Insert the molded end of the tubing into the refrigerator
connection. Tighten the compression nut until it is just
hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not interfere
with the toekick installation.
STEP 13 CONNECT POWER, CLOSE
GRILLE PANEL
• Open the grille panel.
• Plug in the power cord (if necessary) by reaching into
the opening next to the water filter. If access is too
tight, remove the 2 screws holding the water filter
bracket and move aside. Plug in the power cord and
secure the bracket with the original screws.
Bracket
Screws
Master Light
Switches
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are
on.
• The temperature controls are preset at 37°F for the
fresh food section and 0°F for the freezer.
• Allow 24 hours to stabilize before making
adjustments.
Electrical
Outlet Access
STEP 14 START ICEMAKER
Power
Switch
• Slide the switch to ON. The icemaker will begin
operation automatically.
• Be sure nothing interferes with the sweep of the feeler
arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, slide the switch to OFF.
STEP 15 INSTALL TOEKICKS
• Locate the supplied toekicks (shipped taped to the
side of the refrigerator.
• The narrower set of toe kicks will be used with
standard installation. You can discard the other set of
toe kicks.
• Attach the LARGER toekick to the refrigerator using
ONLY the top center hole (1).
• Attach the toekick skirt to the refrigerator using the
three lower slots (2).
2
• A custom toekick can be installed to match or
complement the surrounding cabinetry. Use the
supplied toekick as a template to cut the shape.
21
Icemaker
Feeler Arm
1
Advertisement
Table of Contents
