Step 9 Adjust Door Swing; Step 10 Install Grille Panel - Monogram ZISP480DHSS Installation Instructions Manual

Installation Instructions - Standard Installation

STEP 9 ADJUST DOOR SWING

NOTE: This refrigerator has a 3-position door stop: 90°,
115°, and 130°. When space does not allow the door
to swing open fully to 115°, you may change the door
swing to a 90° opening. A 130° door swing option is
available for standard installation only. Skip this step
if door opening is satisfactory for your installation
situation.
• Open the door to view the bottom hinge. Note the
door stop pin locations. The pin is factory installed in
the 115° position.
• Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 130° or 90°
position.

STEP 10 INSTALL GRILLE PANEL

To insert the framed or overlay panel into the grille:
• Raise the grille panel to the stop position.
Loosen
Side
Trim
Screw
Spring to Accommodate
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
CAUTION
SHARP EDGE HAZARD
The metal panel may be slippery. Grip the metal panel
firmly so the panel does not slip out of the frame and
cause personal injury or damage to the frame.
ATTENTION
RISQUE DE COUPURE : ATTENTION
AUX ARÊTES VIVES
Le panneau en métal peut bêtre glissant. Tenir
fermement le panneau en métal, de manière à ce
que le panneau ne glisse pas en dehors du cadre
en provoquant des blessures corporelles ou des
dommages au cadre.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
17
Adjust Nut Below
Panel Weight
Loosen
Side
Trim
Screw