Table of Contents
Advertisement
Installation Instructions - Flush Installation
STEP 4 INSTALLATION WITH
HOUSEHOLD WATER
FILTRATION SYSTEM
Skip this step if you do not have a household water
filtration system
If the water supply to the refrigerator is from any
household water filtration system, the filter cartridge
should be removed. For better ice and water
performance, remove the filter and install the filter bypass
plug.
Rotate Counterclockwise To
Remove
STEP 5 INSTALL SIDE PANELS
Skip this step when not using side panels.
If you are using 1/4" side panels, they should be
inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting the refrigerator in place.
STEP 6 INSTALL CASE TRIM
The unit arrives with case trim for standard installation
attached. Flush installation case trim is provided. Remove
the three pieces of factory installed case trim (both sides
and top). Install new case trim using supplied right hand
and left hand case trim pieces and case trim screws. A
top piece of case trim is not required for flush installation.
Attach case trim to each side of case as shown in
illustration using case trim screws in holes provided down
each side of the case.
Filter Bypass
Plug
33
STEP 7 ANIT-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially
with any doors open, and must be secured to
prevent tipping forward which could result in
death or serious injury. Read and follow the
entire installation instructions for securing the
refrigerator with the anti-tip system.
AVERTISSEMENT
basculement
Ces réfrigérateurs présentent une partie
supérieure lourde, en particulier avec une porte
ouverte; ils doivent donc être fixés pour prévenir le
basculement vers l'avant et le risque concomitant
de blessure grave ou fatale. Lisez et suivez
les instructions d'installation complètes pour
l'installation du système anti-basculement.
• Cut a 1" x 4" block, 35" long.
• Measure and mark under the soffit, 5-1/4" from the
front edge of the cabinet.
• Secure the wood block under the soffit. From the
bottom of the block to the finished floor should
measure 84". See the illustration.
Connect Power Cord:
• Before pushing the refrigerator into the opening,
plug the power cord into the receptacle. Open the
grille panel and reach into the opening at the back
to grasp the power cord. Pull the power cord into the
opening as you push the refrigerator back.
• Gently push refrigerator into the opening with hands
against front corners.
• Once the refrigerator is pushed into the opening,
use leveling legs to raise the refrigerator until it rests
against the block installed at the top of the opening.
Tip Over Hazard.
Risque de
Advertisement
Table of Contents
