Table of Contents
Advertisement
THE INSTALLATION SPACE
*Finished Width
6"
Electrical
85" max
Area
Finished
Opening
26-3/16"
7"
Water Supply
3 1/2"
*Finished cutout width must be:
39" for 36" models
45" for 42" models
51" for 48" models
Water And Electrical Locations
The opening must be prepared with the electrical and
the cold water supply located as shown.
The Cutout Depth Must Be 26-3/16"
Wooden cleats are required for flush installation. See Side
Cleats on page 27. If 3/4" Overlay panels w/ 90 degree
door swing are to be used then cutout depth must be
26-1/4"
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be located
on the rear wall as shown.
NOTE: GFI (ground fault interrupter) is not recommended.
• The water line can enter the opening through the floor
or back wall. The water line should be 1/4" O.D. copper
tubing or GE SmartConnect
water line and water connection location, long enough
to extend to the front of the refrigerator. Installation of
an easily accessible shut-off valve in the water line is
required.
Design Guide - Flush Installation
36" Models 12"
42" Models 19"
48" Models 22-1/4"
5"
75" From Floor
to Bottom
of Electrical
Area
7"
3 1/2"
kit between the cold
™
DIMENSIONS AND CLEARANCES
35", 41", or 47"
Case Width
*83-1/2"
at
Rear
36", 42" or 48"
Frame to Frame
Depth Including Handles 26-7/8"
Product Clearances
These refrigerators are equipped with a 3-position door
stop. The factory-set 115° door swing can be adjusted
to 90° if clearance to adjacent cabinets or walls is
restricted. Only standard installation can be adjusted to
130°.
115° Door Swing
A
Models
A
36"
13"
42"
13"
48"
15"
Allow minimum clearances for the freezer door
(Dimension A) and fresh food door (Dimension B) for a
full 115° door swing and to allow for pan removal.
For a 90° door swing, allow 4" min. clearance to a wall,
for framed and stainless steel models. Allow 5" min.
clearance for professional series models. If the 90° door
stop position is used, pan access is maintained, but pan
removal is restricted.
24
25-3/8" Framed Models
* Shipping height. The
refrigerator can be
adjusted to fit into a
cutout that is 85" in
height. Use leveling
*84"
legs and wheels
From
for a maximum 1"
Floor
height adjustment.
90° Door Swing
B
B
C
15"
20-5/8"
19"
26-5/8"
*4" Stainless and
Trimmed Models.
20"
28-5/8"
5" Pro Series
23-7/8"
Behind
Frame
C
*Min. Distance
to Wall
Advertisement
Table of Contents
