Customization Basics; Custom Handle Design Guide; Refrigerator Location; Side Panels - Monogram ZISP480DHSS Installation Instructions Manual

CUSTOMIZATION BASICS:

These refrigerators are designed to be customized with decorative panels. Field installed custom door and grille panels
are required.
Optional Accessory Kits
ZKHSS2: Monogram Tubular Stainless Steel handles
designed to fit 3/4" overlay panels.
ZKHPSS1: Professional Tubular Stainless Steel handles
designed to fit 3/4" overlay panels. Kit includes one handle.
Order 2 kits for side-by-side refrigerator models from your
Monogram supplier

CUSTOM HANDLE DESIGN GUIDE

Custom handles must be used for flush installation. For
custom handle installation, counterbore holes in rear of
decorative panels must ensure 1/2" material thickness
remains for handle support.
NOTE: The counterbore must not exceed 1" in diameter.
1/2"
1/4"
3/4"

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often enough
to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
Design Guide - Flush Installation
ZUG2: For side-by-side installation of two trimmed models.
This kit provides for the installation of a unified custom
grille panel to span the width of two units using a framed
or overlay panel.
Minimum distance from handle
side edge to handle center
should be 1-1/4" as shown.
7/8"
0.85"
1/2"

SIDE PANELS

Side panels must be used
whenever the sides of the
refrigerator will be exposed.
The 1/4" side panels will
slip into the side case trim.
Secure the panels to the
refrigerator with stick-on
hook and loop fastener
strips. Order the side
panels from the cabinet
manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
25
1-1/4" 1-1/4"
24"
3/16"
1-7/8"
*84"
*3" to 4"
2-9/16"
* Depending on installation height.