Step 9 Install Framed Panels - Monogram ZIRS360NHLH Installation Instructions Manual

Installation Instructions - Standard Installation

STEP 9 INSTALL FRAMED PANELS

Install Door Panel:
• Open the door to 90°. Remove the 6 Phillips head
screws from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, lift off the trim.
Retain the screws.
• Slide the framed panel into the door trim.
Right hand models shown. Use the same instruc-
tions for left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS,
GO TO STEP 10A.
Use Front Holes
to Secure Trim
Use Rear Holes
to Secure Handle
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in the FRONT screw holes.
• Secure the handle to the door using the REAR screw
holes.
19
Handle
Door Trim
Trim
Door
Standard supplied handle shown
in 1/4" panel position.