Innovative Technology NV11 User Manual page 123

NV11 Manual Set – Section 4
Caution!
Be careful cleaning sensors.
Cleaning the belts is a simple operation. Ensure the validator is enabled (i.e. bezel
lights are illuminated), then remove the bezel:
 The bezel is
removed by pushing
the red locking arms
on both sides of the
validator upwards,
and sliding the bezel
away from the
locking arms
 Lift the bezel off
once the bezel has
been slid fully
across and is clear
of the locating pins
Copyright © Innovative Technology Ltd 2012
When cleaning the recessed front sensor, use a
small soft brush or cotton bud – do not use
anything sharp or abrasive.
b. Slide bezel away from
locking arms
Lift upwards to remove
a. Push locking arms upwards
32
Locating pins
GA963-2