Innovative Technology NV11 User Manual page 120

NV11 Manual Set – Section 4
Ideally, you should also remove the Note Float module prior to cleaning the sensors -
removal is a very straightforward task:
WARNING!
Do not try to disassemble
1. Open both the Note
Float side latches as
shown
2. Carefully lift the Note
Float module upwards
and clear of the
validator head
3. To refit the Note Float
module, reverse the
procedure – make sure
that the electrical
connectors and latches
are lined up correctly
Copyright © Innovative Technology Ltd 2012
Do not attempt to disassemble the Note Float
module – there are no user serviceable parts
inside and trying to disassemble the module
could cause personal injury and will also
damage the unit beyond repair.
Electrical
connector
29
GA963-2