Step 7-Mounting The Rv50 Series Gateway; Mounting Brackets; Flat Surface Mount - Sierra Wireless AirLink RV50 Series Hardware User's Manual

AirLink RV50 Series Hardware User Guide
Table 3-11: Recommended Power Saving Settings — Transitioning from Raven XT or
Raven XE
Feature
LED Power Saving
Mode
Processor Power
Saving Mode
Step 7—Mounting the RV50 Series Gateway
Warning:
least 8 inches (20 cm) away from the operator.
Avertissement :
antennes doivent être à au moins 20 cm de toute personne.
Mount the gateway where:
•
•
•
•
•
•

Mounting Brackets

The RV50 Series gateway comes with mounting screws. An optional DIN rail mounting
bracket (P/N 6000659) is available from Sierra Wireless.

Flat Surface Mount

If you are mounting the RV50 Series gateway on a flat surface, use the mounting screws
that come with the gateway.
Rev. 6 October 2021
Setting
(transitioning from
Raven XT)
Enable
Enable
This gateway is not intended for use close to the human body. Antennas should be at
Ce routeur n'est pas destiné à être utilisé à proximité du corps humain. Les
There is easy access to the cables
Cables are not bent, constricted, close to high amperages or exposed to extreme
temperatures
The front panel LEDs are easily visible
There is adequate airflow
It is away from direct exposure to the elements, such as sun, rain, dust, etc.
It will not be hit or come into contact with people, cargo, tools, equipment, etc.
Setting
(transitioning from
Raven XE)
Enable
Enable
42
Default / Location in
ACEmanager
Disabled by default
(Services > Power Management >
Power Saving Modes)
Disabled by default
(Services > Power Management >
Power Saving Modes)
4117313