Replacing The Brake Roller - Fujitsu fi-6800 Operator's Manual

Chapter 6 Replacing Consumables

6.4 Replacing the Brake Roller

1
Remove all documents from the stacker.
2
If the hopper has been raised, bring it back down to the
lower position.
For information on how to adjust the hopper level, refer to
the Loading Capacity of the Hopper" (page
3
Open the ADF.
For information on how to open the ADF, refer to
Closing the ADF" (page 19).
Be careful not to have your fingers caught
when the ADF closes.
4
Remove the brake roller from the scanner.
1 Open the roller cover. Lift up the cover from the lower middle.
"1.7 Setting
22).
"1.5 Opening/
5
Roller Cover
2 Remove the brake roller. Lift the left side of the roller first, then pull
out the shaft from left to right.
1
2
Install a new brake roller on the scanner.
1 Install the brake roller. Insert the shaft from the right side to the
left.
2
1
2 Close the roller cover. Make sure that both ends of the cover are
locked firmly.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Brake Roller
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Brake Roller
Settings
Appendix
Glossary
100