Setting Automatic Detection For Color/Monochrome [Auto Color Detection] - Fujitsu fi-6800 Operator's Manual

Chapter 8 Operational Settings
Setting Automatic Detection for Color/
Monochrome [Auto color Detection]
Specify the slice level for Auto Color Detection.
1
Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2] 
[Auto color Detection].
3
Select the slice value.
You can select the Slice value from 1 to 255.
Increase the value when black & white documents are recognized as
color documents. Decrease the value when color documents are
recognized as black & white documents.
For information on how to configure the automatic

132).
color/monochrome detection, refer to the scanner
driver's Help.
This setting does NOT appear when Kofax VRS

(optional) is used.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
161