Settings Related To Multifeed Detection; Specifying A Multifeed Detection Method [Multifeed] - Fujitsu fi-6800 Operator's Manual

Chapter 8 Operational Settings

8.5 Settings Related to Multifeed Detection

Specifying a multifeed detection method
[Multifeed]
Multifeed is an error when two or more sheets are fed through
the ADF at once. It is also called a "multifeed" when a different
document length is detected.
Not noticing multifeed errors while scanning may put you in a
situation where important data are missing from the scanned
images. Multifeed detection function is equipped to prevent
such troubles.
When this function is enabled, an error message is displayed
as soon as it detects a multifeed, and stops the scan.
Note that multifeeds cannot be detected in the area of 15 mm
from the leading edge of the document.
1
Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, click [Device Setting 2] 
[Multifeed].
132).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
170