Loading Documents; Preparation - Fujitsu fi-6800 Operator's Manual

Chapter 2 How to Load Documents

2.1 Loading Documents

This section explains how to load documents on the scanner.

Preparation

Prepare the documents as described below.
For details about the paper size and paper quality required for
normal operations, refer to
(page 37).
1
Check the documents.
1 Check if the documents to be loaded are of the same size or
different sizes. Ways to load documents differ depending on
whether the documents are the same size or not.
2 Check the number of sheets. Up to 500 sheets can be loaded (with
2
paper weight of 80 g/m [20 lb], thickness of the document stack
under 50 mm, and the total weight under 5 kg).
For more details, refer to "Loading Capacity" (page
For documents with tabs or non-rectangular

documents, refer to
Non-rectangular Documents" (page
For documents with different widths, refer to

a Mixed Batch of Documents" (page 43)
"Scanning Documents of Different Widths" (page
"2.2 Documents for Scanning"
39).
"Loading Documents with Tabs or
40).
"Scanning
and
70).
2
Fan the documents.
1 Hold both ends of the documents and bend them.
2 Firmly holding the documents with both hands, bend them back in
the opposite direction as follows.
3 Repeat steps 1) and 2) a few times.
4 Rotate the documents by 90 degrees and fan them in the same
manner.
5 Align the edges of the documents.
For information on how to fan documents, refer to the
"Error Recovery Guide".
The Error Recovery Guide is included in the Setup DVD-
ROM. For information on how to install the Error Recovery
Guide, refer to "Installing the Scanner Software" in
"Getting Started".
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
31