Fujitsu fi-6800 Operator's Manual page 137

Chapter 8 Operational Settings
Item Description
Multifeed Specify a method for multifeed
detection. Detect by monitoring the
overlapping, the document length,
or the combination of both.
It can also be configured from the
scanner driver's setup dialog box.
Note that priority is given to the
scanner driver setting.
Multifeed detection Specify this item to enable multifeed
when scanning in detection during manual feeding.
manual feeding
mode
Page Edge Filler Specify a width for the margin off the
(ADF) edge of the scanned image to fill in
black or white.
The margins are filled in white when
the background is white, and filled in
black when the background is black.
It can also be configured from the
scanner driver's setup dialog box.
Note that the priority is given to the
setting with a larger value.
Dropout color Select a color to be dropped out
from the scanned image (black &
white/grayscale only).
It can also be configured from the
scanner driver's setup dialog box.
Note that priority is given to the
scanner driver setting.
Setting/Value
None / Check Overlapping (Ultrasonic) /
Check Length / Check Overlapping and
Length (when detecting from the length
difference, select from 10/15/20 mm)
SCSI or USB Connector:
Disable / Follow driver settings
VRS board (optional) connection:
Disable / Follow Multifeed settings
Top/Left/Right: 0 to 15 mm
Bottom: -7 to 7 mm (in increments of 1
mm)
(A: Image, B: Filled area, A+B: Output)
Red / Green / Blue / None
Factory Default SCSI or USB
Connector

: Configurable
-: Not configurable

Check
Overlapping
(Ultrasonic)

Disable

Top/Bottom/Left/
Right: 0 mm

Green
TOP
Contents
VRS board (optional)
Index
connection
Introduction
Scanner
 Overview
How to Load
Documents
How to Use
the Operator
Panel

Various Ways
to Scan
-
Daily Care
Replacing
Consumables
Troubleshooting
Operational
- Settings
Appendix
Glossary
137