Fujitsu fi-6800 Operator's Manual page 56

Chapter 3 How to Use the Operator Panel
6
Load the documents on the hopper, start up a scanning
application, and perform a scan.
 Depending on the number of sheets scanned, it will be displayed
as follows:
Sheets Display
75
sheets
100
sheets
110
sheets
Documents may not be counted correctly if a multifeed

occurs during scanning.
In the following cases, the scanning returns to normal

from Doc Count Check mode:
- When you only scan the specified pages
- When you scan using a Job Separator
When you press the [Counter Reset] button, the

screen returns to [Doc Count Check Mode] in step 5.
When you press the [Stop] button, it exits [Doc Count

Check Mode] and returns to the [Ready] screen.
Description
Since the count has been set to
100 in step 4, it is -25 sheets.
[-] appears in the top right and
[Count] indicates "25".
If you load additional documents
at this point, you can scan up to
25 sheets.
Since the count has been set to
100 in step 4, it is +/- 0.
[=] appears in the top right and
[Count] indicates "0".
Since the count has been set to
100 in step 4, it is +10 sheets.
[+] appears in the top right and
[Count] indicates "0". Scanning
stops once 100 sheets have been
scanned.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
56