Seagull Models HARMON ROCKET III Assembly Manual page 10

HARMON ROCKET III. Instruction Manual.
2) Locate the two nylon control horns,
Aileron pushrod rod.
two nylon control horn backplates and two
Pen.
machine screws.
2MM x 30 MM.
Clevis.
3) Position the aileron horn on the bottom
side of aileron. The clevis attachment holes
should be positioned over the hinge line.
Control Horn.
Cut.
Mounting Screws.
Mounting Plate.
M2 clevis.
4) Using a 1mm drill bit and the control
M2 lock nut.
horns as a guide, drill the mounting holes
Snap keepper.
through the aileron halves.
5 Mount the control horns by inserting
)
the screws through the control horn bases and
aileron halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
6) Thread one nylon adjustable control
horn onto each aileron control rod. Thread the
horns on until they are flush with the ends of
Repeat the procedure for the other
the control rods.
aileron servo.
10