Controller: Amplitude Modulation; Controller: Pitch Modulation - Yamaha SY55 Product Manual

Summary: Assigns a controller to, and sets the
maximum depth of amplitude modulation ap-
plied by the LFO.
Settings:
CTL# (Control Number) Parameter: 0 ... 120,
AT
RNG (Range) Parameter: 0 ... 127
Procedure: Use the
"CTL#" or "RNG" parameter, then use the
[DATA ENTRY] control, [-1/NO] and [+1/YES]
keys, or numeric and [ENTER] keys to set the
selected parameter as required.
Details: The "CTL#" parameter corresponds to
MIDI control numbers. Standard controller as-
signments are noted in the upper right-hand cor-
ner of the display:
Summary: Assigns a controller to, and sets the
maximum depth of pitch modulation applied by
the LFO.
Settings:
CTL# (Control Number) Parameter: 0 ... 120,
AT
RNG (Range) Parameter: 0 ... 127
Procedure: Use the
"CTL#" or "RNG" parameter, then use the
[DATA ENTRY] control, [-1/NO] and [+1/YES]
keys, or numeric and [ENTER] keys to set the
selected parameter as required.
Details: The "CTL#" parameter corresponds to
MIDI control numbers. Standard controller as-
signments are noted in abbreviations shown in
the upper right-hand comer of the display:
82

CONTROLLER: AMPLITUDE MODULATION

and keys to select the

CONTROLLER: PITCH MODULATION

and keys to select the
Set the CTL# parameter to the number of the
controller with which you intend to control this
function.
The RNG parameter can be set to a value be-
tween 0 and 127. A setting of "0" produces no
change when the assigned controller is operated,
while a setting of "127" produces the maximum
possible change.
If you assign a breath controller (CTL# 2) to
amplitude modulation, for example, the harder
you blow into the breath controller, the greater
will be the depth of the amplitude modulation
produced. Please note that the amplitude modu-
lation sensitivity parameter described on page
?? must be set to an appropriate value before
amplitude modulation will function.
Refer to: "SENSITIVITY (VELOCITY, AMPLI-
TUDE & PITCH MODULATION)," page 67.
Set the CTL# parameter to the number of the
controller with which you intend to control this
function.
The RNG parameter can be set to a value be-
tween 0 and 127. A setting of "0" produces no
change when the assigned controller is operated,
while a setting of "127" produces the maximum
possible change.
If you assign the modulation wheel (CTL# 1) to
pitch modulation, for example, rolling the modu-
lation wheel away from you will produce deeper
pitch modulation. Please note that the pitch
modulation sensitivity parameter described on
page ?? must be set to an appropriate value be-
fore pitch modulation will function.
Refer to: "SENSITIVITY (VELOCITY, AMPLI-
TUDE & PITCH MODULATION)," page 67.
JOB 32
JOB 33