Pitch Bend; Wheel (Amplitude & Pitch Modulation) - Yamaha SY35 Product Manual

VOICE COMMON
Settings: Effect type:
Rev Hall (Reverb Hall)
Rev Room (Reverb Room)
Rev Plate (Reverb Plate)
Rev Club (Reverb Club)
Rev Metal (Reverb Metal)
Delay 1 (Short Single Delay)
Delay 2 (Long Delay)
Delay 3 (Long Delay)
Doubler (Doubler)
Ping-Pong (Ping Pong Delay)
Pan Ref (Panned Reflections)
Early Ref (Early Reflections)
Gate Rev (Gated Reverb)
Dly&Rev 1 (Delay & Reverb 1)
Dly&Rev 2 (Delay & Reverb 2)
Dist&Rev (Distortion & Reverb)
Summary: Sets the range of the pitch bend wheel.
Settings: 0 ... 12 max.*
Procedure: Use the
the lower display line. Use the [-1/NO] and
[+1/YES] keys to select the desired pitch bend
range.
WHEEL (Amplitude & Pitch Modulation)
Summary: Assigns the modulation wheel to ampli-
tude and/or pitch modulation.
Settings: AM (Amplitude Modulation): off, on
PM (Pitch Modulation): off, on
Procedure: Use the
place the underline cursor under the AM or PM
parameter. Use the [-1/NO] and [+1/YES] keys
to turn the selected parameter on or off.
6

PITCH BEND

key to move the cursor to
cursor keys to
Depth: 0...7
Procedure: Use the
place the underline cursor under the effect type
or depth parameter. Use the [-1/NO] and
[+1/YES] keys to select the desired effect or
effect depth.
Details: Setting the depth parameter to "0" is
equivalent to turning the effect OFF. A depth
setting of "7" produces the greatest effect.
Details: Each increment from "0" to "12" repre-
sents a semitone. A setting of "0" produces no
pitch bend. A setting of "12" allows a maximum
pitch bend of plus or minus one octave, while a
setting of "4" allows a maximum pitch bend of
plus or minus a major third.
This range may be more limited in some cases.
An exclamation mark (!) will appear after the
range value when the limit is reached.
Details: Amplitude modulation produces a tremolo
effect while pitch modulation produced a vibrato
effect. This function allows the modulation wheel
to be assigned to produce either or both. This is
only an "off/on" switch, however, and the maxi-
mum depth of modulation to be applied must be
set using the LFO AM Depth and PM Depth
parameters in the ELEMENT TONE edit mode.
When the modulation wheel is assigned to
amplitude or pitch modulation, LFO modulation
can only be applied via the wheel.
If both WHEEL and AFTER TOUCH are as-
signed to modulation control, the controller via
which the highest modulation level is applied
will take priority when both are used simul-
taneously.
cursor keys to