Yamaha SY55 Product Manual page 66

Frequency Note
Summary: Sets the frequency (note) of the AWM
wave for the selected element when the "fix"
mode (above) is selected.
Settings: C-2 ... G8
Procedure: The "Frq.Note" parameter only appears
when the "Frq.Mode" parameter described above
has been set to "fix."
Frequency Tune
Summary: Allows tuning of the AWM wave as-
signed to the selected element.
Settings: -64 ... +63
Procedure: Use the
select the Frequency Tune ("Frq.Tune") parame-
ter. Use the [DATA ENTRY] control, [-1/NO] and
[+1/YES] keys, or numeric and [ENTER] keys to
set the tuning as required.
Summary: All the parameters within this function
determine the "shape" of the amplitude envelope
of the selected element.
Settings:
Mode parameter: nrm, hld
R1/HT, R2, L2, R3, L3, R4 and RR parameters:
0 ... 63
64
and cursor keys to
AMPLITUDE ENVELOPE GENERATOR (AEG)
MODE/LEVEL/RATE
Use the
the Frequency Note ("Frq.Note") parameter. Use
the [DATA ENTRY] control or [+1/YES] and [-1/
NO] keys to select the desired note.
The frequency note can also be set by press-
ing the [ENTER] key — "KBD" will flash on the
display — and then the key on your keyboard
corresponding to the desired note.
Details: The C-2 to G8 range of this parameter
covers a full 10-1/2 octaves. "C3" corresponds
to "middle C" on a keyboard.
Refer to: "NOTE SHIFT," page 59.
Details: Each tuning increment corresponds to a 75/
64-cent change in pitch. The entire tuning range
is therefore 75/64 x 127 (i.e. 64 + 63 incre-
ments) — almost 150 cents. Since 100 cents
equals one semitone, the tuning range is approxi-
mately one and a half semitones. A setting of
"0" produces normal pitch (A3 = 440 Hertz).
Please note that this parameter is used to in-
dividually tune different elements within a
voice. Overall tuning control is provided by the
MASTER tune function in the UTILITY mode.
Refer to: "MASTER TUNE" on page 132.
"DETUNE" on page 60.
Procedure: If the Mode ("Mode" on upper LCD
line) parameter is not already selected, use the
and cursor keys to select it, then use
the [DATA ENTRY] control, [-1/NO] and [+1/
YES] keys to select the "nrm" (normal) or "hld"
(hold) setting. Once the desired mode has been
selected, use the
select the various rate and level parameters in
turn (R1/HT, R2, L2, R3, L3, R4 and RR), using
the [DATA ENTRY] control or [+1/YES] and [-1/
NO] keys, or numeric and [ENTER] keys to set
the value of each. "R1" (Rate 1) will appear
and cursor keys to select
JOB 13
and cursor keys to