Yamaha SY55 Product Manual page 127

• TRACK1
•TRACK 2
• TRACK 2 (Result with new measure numbers.)
Summary: Erases all note and event data from the
specified measure or range of measures in the
specified track.
Settings:
Track number: 1 ... 8.
Beginning and end measure numbers.
Procedure: Use the [ ] and [ ] cursor keys to
select the track (leftmost parameter), beginning
measure (center parameter), or end measure
(rightmost parameter). Use the [DATA ENTRY]
control, [-1/NO] and [+1/YES] keys, or numeric
and [ENTER] keys to select the track and meas-
ure numbers.
After selecting the desired track and meas-
ures, press the [ENTER] key. "Sure?" will appear
on the upper line of the display. Press the [+1/
YES] to erase or [-1/NO] to cancel the operation.
"Executing!" will appear on the display dur-
ing erase, and "Completed!" will appear briefly
when the erase operation is finished.
Details: A copy operation overwrites the data from
the beginning of the specified destination meas-
ure with the data from the source measure(s).
Previous data in the overwritten measures is
therefore lost.
ERASE
Details: An erase operation leaves the specified
measures intact but blank.
•
TRACK 1
•
TRACK 1
SEQUENCER MODE
Measures 4 — 6
"blank," contain
only rests.
JOB 6
1 2 5