Disassembly Procedures
!
EMI Filter Removal
1. Disconnect power supply to unit.
2. Remove Top Cover.
3. Remove wiring connectors and ground wires.
Console/Machine Control Board Removal
1. Disconnect power supply to unit.
2. Remove Dispenser drawer.
3. Remove 2 screws located behind dispenser. Remove
1 screw on console right side.
18
WARNING
16023430 Rev. 0
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
4. Tip Console to access connectors.
NOTE: Clip wire ties if necessary to gain access to
Control Board.
CAUTION: Do not reassemble washer without
replacing clipped wire ties. Do not remove
wire ties if replacement are not available.
5. Remove connectors from Control Board back.
©2004 Maytag Services