Mems Sensor Removal; Reactor Removal; Emi Filter - Maytag MAH6700AW Series Service

Disassembly Procedures
!

MEMS Sensor Removal

1. The motion sensor/bracket assembly goes between
the cross brace and upper plate on one side and over
the tab on the plastic control panel, on the other side.
The motion sensor wire harness attachs to location
CN11 on control board.

Reactor Removal

1. Disconnect power supply to unit.
2. Remove Top Cover (See "Top Cover Removal").
3. Remove single attachment screw on cross brace.
4. Twist Reactor counterclockwise to remove.
©2006 Maytag Services
WARNING
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
NOTE: The reactor coil is wired in series with line 1
internally in the Control Board. An open coil or
loose electrical connection would result in a
"dead" board complaint. A resistance check
across the coil leads should indicate less than 1
ohm.
EMI Filter Removal
1. Disconnect power supply to unit.
2. Remove Top Cover (See "Top Cover Removal").
3. Loosen 13mm acorn nut and slide EMI Filter out of
bracket.
NOTE: Mark the wire locations on the EMI before
removing the terminals.
16026186 25