Removing The Pet Hair Filter; Removing The Agitator - Maytag Pet Pro Technical Manual

6. Using a 1/4" nut driver, remove the hex-head screw securing the ACU to
the Top Panel of the washer as shown in above figure. Slide ACU to the
left and lift to remove.

Removing the Pet Hair Filter

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Raise the Lid.
4. Grab the cap and twist to unlock.
FOR SERVICE TECHNICIAN'S USE ONLY
5. Remove the filter from the agitator post.

Removing the Agitator

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Complete steps 1-5 from Removing the Pet Hair Filter.
2. Remove the 7/16" (11 mm) hex-head bolt from the agitator, then lift and
remove the agitator from the basket.
NOTE: Any time the impeller bolt is removed, Loctite
(Threadlocker Blue 242 or similar adhesive) must be reapplied,
®
otherwise the bolt will eventually work itself loose resulting in a
second service call.
adhesive
®
37