Compactpci Mechanical Design; Compactpci Bridge; I/O Connectivity - Advantech MIC-3397 User Manual

– 5 ~ 100 Hz, 1.06 Grms with CFast/SSD (without on-board 2.5" SATA HDD)
on 8HP SKU
 Vibration (Non-operating): 5 ~ 500 Hz, 2 Grms
 Shock: 10 G (without on-board 2.5" SATA HDD), 11 ms
Shock (Non-operating): 30 G, 11ms (On dual slot SKU)


Board size:
– 6U/1 slot width (4HP): 233.35 x 160 x 20 mm (9.2" x 6.3" x 0.8")
– 6U/2 slot width (8HP): 233.35 x 160 x 40 mm (9.2" x 6.3" x 1.6")

Weight:
– 6U/1 slot width (4HP): 0.83 kg (Bare board)
– 6U/2 slot width (8HP): 1.35 kg (Bare board)
1.2.15

CompactPCI Mechanical Design

MIC-3397 series is assembled with a copper heatsink for CPU & MXM, with alumi-
num heatsink for PCH. However, forced air cooling in the chassis is still needed for
operational stability and reliability.
1.2.16

CompactPCI Bridge

The MIC-3397 uses a Pericom PI7C9X130D universal bridge as a gateway to an
intelligent subsystem. When configured as a system controller, the bridge acts as a
standard transparent PCI Express to PCI/PCI-X Bridge. As a peripheral controller it
allows the local MIC-3397 processor to configure and control the onboard local sub-
system independently from the CompactPCI bus host processor. The MIC-3397 local
PCI subsystem is presented to the CompactPCI bus host as a single CompactPCI
device. When the MIC-3397 is in drone mode, the Pericom PI7C9X130D is electri-
cally isolated from the CompactPCI bus. The MIC-3397 receives power from the
backplane, supports rear I/O.
The Pericom PI7C9X130D PCI bridge offers the following features:
 PCI Interface:
– Full compliance with the PCI Local Bus Specification, Revision 3.0
– Supports 3.3V PCI signaling with 5V I/O tolerance
 Supports transparent mode of operations.
 Supports forward bridging
 64-bit, 66MHz asynchronous operation
 Provides two level arbitration support for 7 PCI Bus masters
 16-bit address decode for VGA
 Usable in CompactPCI system slot
Please consult the Pericom PI7C9X130D data book for details.
1.2.17

I/O Connectivity

For MIC-3397, the front panel I/O is provided by two RJ-45 Gigabit Ethernet ports,
one RJ-45 COM port, three USB 2.0 ports, one VGA port. Its onboard I/O consists of
two SATA channels, one is connected to a daughter board for 2.5" SATA HDD or
NAND flash and the other is connected to a CFast slot. Rear I/O connectivity is avail-
able via the following CompactPCI connectors:
 J3: two Gigabit Ethernet links to the backplane for PICMG 2.16 packet switch,
two SATA port, PCIe Gen3 x4 on the RTM.
 J5: Two Gigabit Ethernet LAN ports, two COM ports, three USB ports, one PS/2
port (for keyboard/mouse) and one VGA port on the RTM.
7 MIC-3397 User Manual