Table of Contents
Advertisement
Gigabit Ethernet port can be selected in the BIOS menu. These are mutually exclu-
sive and can be any one of:
Front I/O (RJ-45)
Rear I/O (Rear Transition Module)
PICMG 2.16
User can access LAN1 via front panel. LAN2 is accessible via front panel & rear I/O,
LAN 3 via rear I/O, LAN4 & LAN5 can be connected to PICMG 2.16 on backplane.
1.2.7
Storage Interface
The MIC-3397 supports four SATA II interfaces. The SATA1 interface can be routed
to an on board 2.5" SATA hard disk drive or one 8G on board NAND flash by switch;
the SATA 2 interface is routed to an on board Cfast module; SATA 3 & 4 are reserved
to rear I/O via J3 connector for user customization.
1.2.8
Serial Interface
Two serial ports are from Super IO and one from PCH. One RJ-45 COM1 port (RS-
232/422 interface) is provided on the front panel. Two COM ports (RS-232/422/485
interface) are routed to a rear I/O module as RJ45 or DB9 port via the J5 connector.
1.2.9
USB Port
Six USB 2.0 compliant ports are provided. Three ports are routed to front panel con-
nectors; three ports are routed to rear I/O through the J5 connector.
1.2.10
LEDs
Four LEDs are provided on the front panel as follows:
Table 1.3: LED Indicator for the MIC-3397
Function
Hot Swap Status
HDD Status
Power Status
Master/Drone mode status Green
1.2.11
Watchdog Timer
An onboard watchdog timer provides system reset capabilities via software control.
The programmable time interval is from 1 to 255 seconds.
Color
Indicator
Blue
The board can be safely removed from system
Yellow
HDD is activity
Green
The power is provided to the board.
LED On-> "Master" mode.
LED Off-> "Drone" mode.
5
MIC-3397 User Manual
Advertisement
Table of Contents
