Detaching And Refitting The Eject Fan Motor; Direction Of Installing The Principal Fan Motors - Kyocera FS-6025MFP/B Service Manual

(3) Detaching and refitting the eject fan motor

Procedure
1. Remove the rear cover.
(See page 1-5-5)
2. Remove the connector and then
remove two wires from three hooks
respectively.
3. Remove two screws and then remove
the eject fan motor.

(4) Direction of installing the principal fan motors

When detaching or refitting the fan moter,be careful of the airflow direction (intake or exhaust).
Eject fan motor
Screw
Screw
Eject fan motor
(Rating label:out side)
Controller fan motor
(Rating label:inside)
Exhaust
Intake
1-5-40
Wires
Figure 1-5-70
Power source fan motor
(Rating label:inside)
Figure 1-5-71
2K3/2L3
Connecter
Hooks
Intake