Modifying Fis For A Cluster Server - DEC MicroVAX 3100 Owner's Manual

$ @SYS$UPDATE:VMSLICENSE
IR~urnl
NOTE:
Care should be taken to ensure that the information (as read from
the PAK) is entered correctly.
If you make a mistake while entering any PAK, continue the data entry
sequence and reject the entered data at the end of the sequence when the
system asks you to confirm that the data entered is correct. The system
then gives you the opportunity to reenter the data correctly.
NOTE:
Care should be taken when reentering data to ensure that the PAK
data is entered correctly.
See the VMS License Management Utility Manual for any additional
information you may need.
Appendix G and Appendix H provide information on backing up the system
disk and tailoring VMS files respectively. Read this information carefully
and decide the exact sequence of backup and tailoring functions necessary,
based on the amount of tailoring required (if any) and the backup resources
available to you.
See the VMS Installation and Operations Manual for further information
on entering Program Authorization Keys (PAKs), customizing and testing
the system, startup and shutdown, and backup procedures.
2.7.2 Modifying FIS for a Cluster Server
If you intend to use your system as a cluster server, you will require a node
name and a node ID which can be obtained from your Network Coordinator.
Then, respond to the system prompts as follows:
Do you want to enter Customer's cluster and password information
( YIN)?
Y I Return
I
Will this node be a cluster member
(YIN)?
Y I Return
I
A series of system prompts are then displayed. Respond to the system
prompts as indicated in Table 2-1.
Installing Your System
2-19