DEC MicroVAX 3100 Owner's Manual page 35

Figure 2-2) to halt the system and set up the system default settings (see
Section 2.4). Then reboot the system using the.command:
»>
BOOT DKA300
I
Return
I
Mter the system has rebooted, status information is displayed as follows:
Startup processing continuing ...
%SET-I-INTEST, login interactive limit=64, current interactive value=O
SYSTEM Job terminated at 31-DEC-1988 15:00:00.00
Accounting information:
Buffered I/O count: 133
12
325
Peak working set size: 401
2379
o
o
00:01:31.24
Direct I/O count: Peak virtual size:
Page faults: Mounted volumes:
Charged CPU time:
o
00:00:55.23
Elapsed time:
At this point, the VMS operating system is running. However, you must
perform certain post installation tasks before you can use the system. Press
RETURN and the system asks you for a user name and password. Log in
to the SYSTEM account as follows:
Welcome to VAX/VMS
USERNAME: SYSTEM
I
Rffiurnl
PASSWORD: PANCAKES
I
Return
I
%LICENSE-I-NOLICENSE, no license is active for this software product
%LOGIN-LOGOPRCON, login allowed from OPAO:
Welcome to VAX/VMS
Always know your password. If your do not enter the correct password, the
system displays the following message:
User authorization failure
If you forget your password, follow the instructions for breaking into the
system in the Guide to Setting Up a VMS System.
You should now perform the following operations:
• Register any Product Authorization Keys (PAKs) that you have received
with your system.
• Backup the system disk.
• Delete unwanted VMS files.
To register PAKs, enter the following:
2-18 MicroVAX 3100 and VAXserver 3100 Owner's Manual