DEC MicroVAX 3100 Owner's Manual page 159

G.1.1 Installing Standalone BACKUP on System Disk
You can install standalone BACKUP in any available root directory on the
system disk from [SYSl] to [SYSE]. However, DIGITAL has established
[SYSE] as the standard directory for standalone BACKUP.
To install standalone BACKUP in [SYSE] on the system disk, use the
following procedure:
1. Log in to the SYSTEM account.
2. Enter the following command:
$
@SYS$UPDATE:STABACKIT SYS$SYSDEVICE: I Rffiurnl
The procedure places the files in the directories [SYSE.SYSEXE] and
[SYSE.SYS$LDR] on the system disk. It lists the files as they are
copied. When the procedure finishes, it displays the following message:
The kit is complete.
3. To boot standalone BACKUP from the system disk, see Section G.1.2.
G.1.2 Booting Standalone BACKUP from the System Disk
To boot standalone BACKUP from the system disk, use the following
procedure:
1. If the VMS operating system is not running, go to step 2.
If the VMS operating system is running, enter the following command
to log into the SYSTEM account:
$
@SYS$SYSTEM:SHUTDOWN \ Return
I
Answer the questions. When the procedure asks if an automatic
system reboot should be performed, press RETURN for NO. When the
procedure is finished, it displays the following message:
SYSTEM SHUTDOWN COMPLETE - USE CONSOLE TO HALT SYSTEM
2. Stop the system by pressing the halt button on the rear of the system
unit. See Figure 2-2.
""'-.,
~...7
3. Enter the BOOT command in the following format:
»> B/EOOOOOOO device name \ Return
I
G-2 MicroVAX 3100 and VAXserver 3100 Owner's Manual