Configuration Display - DEC MicroVAX 3100 Owner's Manual

If a self-test results in a failure, run the configuration display to show
any error codes.
6.4 Configuration Display
To display your system configuration, perform the following steps:
1. Put the system in console mode by pressing the halt button on the rear
of the system unit.
NOTE:
Read your operating system documentation for shutdown
procedures before halting the system.
2. Enter TEST 50 at the console prompt, and press RETURN. This
procedure displays the system configuration, Ethernet ID, ROM
revision levels, and status information. The mnemonic for each device
in the configuration is listed in Table 6-3. Error information in
this display is valuable to your service representative. Have this
information ready if you must call for service. See Chapter 4 and
Appendix B for additional information.
6-10
MicroVAX 3100 and VAXserver 3100 Owner's Manual