Headlights Switch - Can-Am SPYDER F3TM 2016 Operator's Manual

SECONDARY CONTROLS
rmo2014-003-004_f
CRUISE CONTROL PREVIOUSLY SET
1. Push down button to reduce the speed
setting
Stopping the Cruise Control
To completely stop the cruise control
operation, slide the cruise control but-
ton to the left.
rmo2014-003-004_h
1. Slide button to OFF
NOTE: The cruise control SET indica-
tor will disappear in the multifunction
gauge.
Cancelling the Cruise Control
Any of the following event will cancel
the cruise control and give you back
the throttle control. It then can be re-
sumed if desired.
– Pressing the brake pedal.
– Squeezing the clutch lever or if
clutch slippage occurs (SM6 mod-
els).
– Gear change (SE6 model).
– Any vehicle stability system inter-
vention.
______________
18
NOTE: When cancelling the cruise
control, you may activate the throt-
tle lever up to the desired position to
make the transition smoother.
Resuming the Cruise Control
If the cruise control was cancelled and
the cruise control switch is still at the
ON position, the cruise control oper-
ation can be resumed by pushing the
cruise control button up. The cruise
control will then recover the previous
set speed.
rmo2014-003-004_i
CRUISE CONTROL PREVIOUSLY
CANCELLED
1. Push up button to RESUME
NOTE: The cruise control SET indica-
tor will come on in the multifunction
gauge.

6) Headlights Switch

Headlights
The switch is near the left handgrip,
and is used to select high or low beam
for the headlight. The headlights au-
tomatically turn on when the engine
reaches 800 RPM.
To select high beams, push the switch
to the front position. To select low
beams, push the switch to the back
position.
To flash the high beams, push the
switch down, then release it. The high
beams will stay on as long as you hold
down the switch.