Can-Am SPYDER F3TM 2016 Operator's Manual page 109

1
C
D
rmo2008-027-105_b
TYPICAL - HEADLIGHT REFLECTION ON
TEST SURFACE — HIGH BEAM (SINGLE
HEADLAMP)
1. Focus point
A. 688 mm (27-3/32 in) above ground
B. 618 mm (24-21/64 in) above ground
C. 564 mm (22-13/64 in) above ground
D. 514 mm (20-15/64 in) above ground
7. Select low beam.
8. Beam aiming is correct when the
top line of headlight reflection is be-
tween lower marks.
rmo2016-009-009_a
HEADLIGHT REFLECTION ON TEST
SURFACE — LOW BEAM (SINGLE
HEADLAMP)
1. Top line
A. 688 mm (27-3/32 in) above ground
B. 618 mm (24-21/64 in) above ground
C. 564 mm (22-13/64 in) above ground
D. 514 mm (20-15/64 in) above ground
Headlights Aiming Adjustment
(North American Models)
Using a 10mm wrench, adjust each
headlight by turning the headlight ad-
juster located on the headlight hous-
ing. Turn clockwise to raise headlight
and counterclockwise to lower head-
light. Adjust both headlights evenly.
A
B
rmo2015-008-771_a
RH SIDE SHOWN
1. Headlight adjuster
Headlights Aiming Adjustment
(European, Australian and Japanese
Models)
High Beam
Using a 10mm wrench, adjust each
headlight by turning the headlight ad-
juster located on the headlight hous-
ing. Turn clockwise to raise headlight
and counterclockwise to lower head-
light. Adjust both headlights evenly.
rmo2015-008-771_a
RH SIDE SHOWN
1. Headlight adjuster
Low Beam
Refer to
move the following.
______________
MAINTENANCE PROCEDURES
BODY PANELS
section and re-
107